Tascam DM-3200 owner manual Viewing a list of location memories, Manual location, Repeat play

8 – Remote operation : Location memories

NOTE

If a pre-roll time has been set (“Locate Preroll” on page 98), the controlled device will locate to the loca- tion memory point, minus the value set as the preroll time.

Viewing a list of location memories

To view a popup list of all the location memories which have been stored:

•Press the LOCATE LIST key.

•The location memory source (timecode or MTC) is shown, along with the value of each location memory. The DIRECT indicator also lights.

•Press a number key (from 0 through 9) to locate to a location point on the list while the list is showing.

Manual location

It is also possible to enter a location point manually, (from a cue list, for instance) and locate straight to it.

1Press the MANUAL key so that the indicator lights.

2Use the number keys to enter a number in hh:mm:ss (and optionally frames) format.

3When the ENTER key is pressed, the con- trolled device starts to locate to the location point just entered.

This location point can be stored by pressing the MEMO key so that the indicator flashes, followed by pressing the MANUAL key again.

To locate to this point again after storing the location point, press the MANUAL key, followed by the ENTER key.

Note that the pre-roll time (“Locate Preroll” on page 98) does not apply here.

Repeat play

Location memories 8 and 9 (accessed with the 8 and 9 keys) are used as the start and end points of a repeat loop that can be played by pressing the REPEAT key in the MACHINE CONTROL section.

While the repeat loop is in progress, the indicator flashes while the playback position is outside the

loop points, and lights steadily while it is inside them.

The repeat is always between points 8 and 9, regard- less of their order. These points must be more than 5 seconds apart.

100 TASCAM DM-3200 User’s Manual