6 – Effects : Setting up the effects
Use the cursor keys and ENTER to select an effect from PRESET 1 (TC Works reverb), PRESET 2 (TAS- CAM effect) or any of the four memory banks on the CF card.
Use the wheel or PD 4 encoder to scroll through the entries and press the POD 3 switch to recall the entry to the effect loop.
Press the EFFECT key once more to return to the set- ting screen:
Figure 6.3: Effect setting
The exact screen depends on the effect selected, as explained below, but the top row is common to all effects, whether TASCAM or TC Works:
POD 1 | POD 2 | POD 3 | POD 4 |
INPUT type selection | INPUT Sets the input level to |
(mono or stereo) | the effect |
MIX From dry (0%) to fully wet OUTPUT output level (100%)
For guitar compressor, distortion, compressor, exciter,
Figure 6.4: Common effect parameters (Row 1)
TASCAM effect parameters
The TASCAM effects (chorus,
theses in (UPPERCASE)). When the basic effect is cho- sen from the library, all
POD 1 | POD 2 | POD3 | POD 4 |
|
|
|
|
Chorus (CHORUS) |
|
|
|
|
|
|
|
Rate (RATE) | Depth (DEPTH) | Feedback (FEEDBACK) | |
0.0Hz – 10Hz | 0% – 100% | 0.05ms – 500ms | 0% – 90% |
|
|
|
|
|
|
| |
|
|
|
|
— | Threshold level (THRESHOLD) | Knee shape (KNEE) | Center frequency (CNTR FREQ) |
| 0.50 – 1.00 | 1.0kHz – 10.0kHz | |
|
|
|
|
Delay (DELAY) |
|
|
|
|
|
|
|
Delay time (DLY TIME) | Feedback time (FB.TIME) | Feedback level (FEEDBACK) | Feedback type (TYPE) |
0.05ms – 650ms | 0.05ms – 650ms | 0% – 90% | |
|
|
|
|
Distortion (DISTORTION)a |
|
|
|
– | Drive ratio (DRV RATIO) | Drive boost (DRV BOOST) | Drive EQ (DRV EQ) |
| 0 – 42 | x1 – x32 | Overdrive 1/Overdrive 2/ |
|
|
| Distortion 1/Distortion 2/ Amp |
|
|
| 1/Amp 2 |
|
|
|
|
Table 6.5: TASCAM effect parameters
82 TASCAM