RCA VR628HF manual ON-SCREEN Displays

For example, if you record a 30-minute program at the beginning of the tape and you want to go to the end of that program to begin another recording, you would:

1.Press INFO twice on the remote to display the time counter.

2.Press CLEAR to reset the time counter to 0:00:00.

3.Press FORWARD (FWD) to forward the tape until the time counter reads 0:30:00.

,Press STOR This is the approximate end of the program. (You may want to press PLAY to verify.) Now, you can begin recording at this spot.

,Press INFO to remove the time counter from the screen and return to the normal display mode.

0:30:00

HoursI

Minutes

Seconds

ON-SCREEN DISPLAYS

The INFO button shows the status of the VCR (STOP, PLAY, RECORD, etc.), channel number, time counter, date, time, and tape speed on the TV screen. The date and time must be set before they can be displayed.

1.Press INFO to see all of the on-screen displays. These will automatically time out after a few seconds

,Press INFO again to have only the time counter remain on the screen. This display doews not time out automatically.

. Pressing INFO a third time disables the on-screen displays. This feature prevents you from accidently recording on- screen displays while copying tapes.

4.Press INFO to see all of the on-screen displays again.

1 Sl:op Ch 05 0:30:00

1_/18/97 Tue 01:30PM SLP

On-screendisp_y

_imes ou_

20:30:00

Time counter only (does not time out)

3

On-screen display off

45