Startup
1. Check accessories with VCR.
Contact your dealer if any items are missing.
|
|
| |
Remote | 2 va” Batteries | Power Cord | RF Coaxial Cable |
(Stock No. 218103) |
| (Stock No. 218104) | (Stock No. ~oSOSS) |
2. Attach power cord to back of VCR.
3. Insert batteries in remote.
4.mm on the TV.
A.Turn on the TV.
B.If you used one of the basic hookups, tune the TV to the channel selected with the CH4 Cti3 switch on back of VCR.
If you used one of the advanced hookups, t”ne the TV to the TV’s video input. (See TV’s owner’s manual for details.)
5.lWn on the VCR.
A.Press VCR1 (VCR2) on the remote.
6.Place channels in the VCR’s memory (AutoProgram).
Channels 2 through 13 are in the VCR’s memory when you first hxn it on. Pressing CHANNEL up or down stops on these channels. To get additional channels available on your antenna or cable system, you must AutoProgram the VCR.
A. Press VCR1 (VCR2) to set remote to control VCR.. | , |
B. Press PROG/VCR+ on the remote to see the VCR MAIN MENU on |
|
the TV screen. If the menu does not appear on the TV screen: |
|
Make sure TV is tuned to same channel as CH4 CH3 switch on |
|
VCR or the TV’s video input (refer to TV’s manual). |
|
Press VCR1 (VCR2). and then press PROG/VCR+. |
|
If you use a basic hookup, check VCR indicator in display panel - | II |
it should be on. Press NNCR to turn it on. | |
Check the connections. |
|
C.When menu appears, press 5 to select SET UP VCR.
D.Press 1 to begin AUTOPROGRAM CHANNELS.
Wait until the channel numbers stop changing. This takes about
one to two minutes. The TV will then tune to the lowest channel found Pressing CHANNEL up or down will select only the active channels. The VCR automatically selects ANTENNA or CABLE. If you need to change the setting manually, press 3.
continued
“CR fa*,N HEN”
I “CR PLUS
z PROGRP.IITllER
3REVlEY PROGRI~S
4SET “CR CLOCK
5SET UP “CR
on next page
lllrl 1
