RCA VR688HF manual Remote Control, Component Buttons, VCR Function Buttons

Using the Remote Control

Remote Control

Your back-lit remote has a light button ( ) that glows in the dark. Press this button to light the buttons on the remote. The remote buttons remain lit when they are pressed within a few seconds of each other. If a button is not pressed within approximately eight seconds, the light turns off to conserve battery power.

Component Buttons

Press one of the buttons to set the remote to operate that component.

	CR	SAT
	V		•CAB
				LE
	1
PWR	VCR•DVD		AUX		TV

2

REW PLAY FF

REC STOP PAUSE

DISPLAYSEARCH

	CHAN
VOL	VOL

AUX (Auxiliary)

Can be programmed to control a compatible RCA audio or video component. See page 25.

SAT•CABLE

Turns on a compatible cable box or satellite receiver. See page 24.

Used with PWR button to turn on another brand of cable box or receiver, other than RCA, when the remote is programmed to control that cable box or receiver. See page 24.

TV

Turns on a compatible RCA, ProScan, or GE TV and sets the remote to control the TV.

Used with PWR button to turn on another brand of TV, other than RCA, when the remote is programmed to control that TV. See page 23.

VCR1

Turns on a compatible RCA, ProScan, or GE VCR and sets remote to control the VCR.

VCR2•DVD

Turns on a compatible RCA, ProScan, or GE VCR and sets remote to control VCR when it has been setup. See page 22.

Used with PWR button to turn on a compatible RCA or ProScan LaserDisc player. See page 22.

Can also be programmed to control a compatible RCA DVD component.

	CHAN
MUTE	PREV CH

VCR Function Buttons

Press VCR1 (VCR2•DVD) to set remote to control the VCR to use the function

1	2	3
4	5	6
7	8	9
INPUT	0	TV•VCR
CLEAR	•	SPEED
C	PROG
	MENUM
F.ADV		EDIT

e

MOVE

+ 4

SLOWTRACKING

_ 3

CHAN Up or Down

Selects next higher or lower channel in the VCRÕs channel memory.

CLEAR

Resets time counter to 0:00:00.

Allows you to change entries when setting the clock or VCR for a VCR Plus+ or timer recording.

DISPLAY

Shows VCR operating displays on the TV screen.

Displays program information when available.

Displays the time counter.

EDIT

Signals two properly connected compatible VCRs to begin copying a tape. See page 48.

F.ADV (Frame Advance)

Lets you view one frame with each press of the button while the tape is paused.

FF(Fast Forward)

Fast forwards the tape when the VCR is stopped.

Searches the picture in forward motion during playback.

INPUT

Turns the line input on or off.

L1 or L2 will appear in the VCRÕs display panel and VIDEO1 or VIDEO2 will appear on the TV screen.

Line input refers to the signal coming from the component connected to the audio/video input jacks on the back (L1) or front (L2) of the VCR.

MENU•PROG

Displays the VCR MAIN MENU on the TV screen.

Removes a menu from the screen.

MOVE Arrow Buttons ( ) Allow you to move through the menus, enter data and change settings of selected features. See page 10.

Numbers (0 through 9) Select a channel up to 99 by pressing two numbers.

Select a cable channel over 99 by pressing and holding 1 until 1– – appears on the screen. Then press the other two numbers.

20