RCA VR688HF manual Back Panel, Display Panel

References

Location of Controls

Back Panel

				IN
MONO	L			FROM
L				ANTENNA
R	R	VIDEO		OUT
	IN	OUT		TO
IN	OUT		CH	TELEVISION
	AUDIO	3		4

CH3 CH4 Switch VIDEO and AUDIO (R and L MONO) IN Jacks

Selects the channel to which you will tune the TV to see the VCR picture if you connect the VCR using one of the basic hookups.

IN FROM ANTENNA Connector

Receives the signal from an antenna, cable system, or satellite system that is attached to this connector.

OUT TO TELEVISION Connector

Passes signal to TV using the cable supplied.

Receives signals from another component, like a VCR or camcorder, when it is connected to these jacks. Use INPUT to select L1 in the VCRÕs display panel.

Attach a component that is not stereo to the L•MONO jack to hear sound on both channels.

VIDEO and AUDIO (R and L) OUT Jacks

Sends signals from VCR to another component, like a TV monitor or VCR, when it is connected to these jacks.

Display Panel

This VCR has a feature where you can change the brightness level of the fluorescent display panel.

1. Press MENU•PROG on the remote to see the VCR MAIN MENU on the TV screen.

2. Press 6 to display the PREFERENCES menu.

3. Press 4 to select Front Panel: AUTO, BRIGHT, or DIM.

¥Select AUTO to keep the display panel bright when VCR is on and dim when it is off.

¥Select BRIGHT to keep the display panel bright.

¥Select DIM to keep the display panel dim.

VCR MAIN MENU

1 VCR Plus+

2 Timer Recordings

3 Time

4Channels

5 Setup

6 Preferences

		PREFERENCES
1		Remote Control: VCR1
2		Auto Play:	ON
3		Auto TV/VCR:	ON
	4	Front Panel:	AUTO
5		CA Marking:	ON
6		CA Playback:	AUTO
7		CA Display:	BLUE
8		Set Auto Repeat
0		Exit

50 continued on next page