RedMax EDG2300R OP5 OP6 OP7 OP8, Stopping Engine, How to operate Reverse control OP8, Shift lever

OP5

OP6

OP7

OP8

English

7. Operation

■STOPPING ENGINE

•Gradually decrease the engine speed to an idle speed, and then slide ignition switch to "STOP" position.

(1)Ignition switch

(A) RUN

(B) STOP

■BORING OPERATION (OP6, OP7)

•Keep the engine running at full throttle during operation.

•Keep the drill going straight. Tilted boring can cause the drill to bend.

•Avoid touching the spark plug lead during operation.

•Always hold unit firmly with both hands on handles and body well balanced.

•Operate at a high engine speed and let drill bit do the work. Do not force bit into hole.

•If material become twisted around drill bit, stop engine, allow unit to cool and remove wire from spark plug before attempting to clear bit.

•Stop engine and inspect unit if abnormal vibration or noise is generated.

How to operate Reverse control (OP8)

•Decrease engine speed to idle and move shift lever to R (Reverse) position, then accelerate to pull out.

•Shift lever may not move unless engine is running. If so, turn drill chuck a little bit by hand.

•The purpose of Lock control and Reverse control is mainly for easy pullout of bit.

(1) Shift lever

28