2.Attach the Rear Stabilizer (24) to the rear of the Frame (1) with four M8 x 25mm Patch Screws (73).
3.Remove the four M10 Nylon Locknuts (85) and the four M10 Split Washers (103) from the welded bolts near the front of the Frame (1).
While a second person holds the Upright (2), con- nect the Upper Wire Harness (15) to the Lower Wire Harness (39).
Align the holes in the bracket on the lower end of the Upright (2) with the welded bolts on the Frame (1). Lower the Upright, feeding the Upper Wire
Harness (15) and the Lower Wire Harness (39) up into the Upright, until the welded bolts are fully inserted into the bracket. Be careful to avoid pinching and damaging the Wire Harnesses.
Place the four M10 Split Washers (103) onto the welded bolts on the Frame (1). Tighten the four M10 Nylon Locknuts (85) onto the welded bolts.
4.Feed the Upper Wire Harness (15) up through the indicated hole in the Console Bracket (3). Attach the Console Bracket to the Upright (2) with four M8 x 19mm Button Screws (81). Be careful to avoid pinching and damaging the Upper Wire Harness.
Attach the Water Bottle Holder (13) to the Upright (2) with two M4 x 19mm Screws (92). Note: The water bottle holder is designed to be used with your own water bottle.
6
2 |
| 1 |
|
| |
| 73 |
|
|
| 73 |
|
| 24 |
3 | 85 |
|
|
| |
| 2 | 103 |
|
| |
|
| Be careful to |
|
| avoid pinching |
|
| and damaging the |
|
| Wire Harnesses |
| Bracket | (15, 39) during |
| this step. | |
|
| |
| 15 |
|
| 39 |
|
|
| 1 |
| Welded |
|
| Bolts |
|
4 |
| 81 |
|
| |
| 3 |
|
|
| Hole |
| 15 |
|
| 2 |
|
|
| 13 |
|
| 92 |
