INSTALLATION
INSTALLATION OF THE
DC SPARKER
(APPLIES ONLY TO LP UNITS)
1)Attach the ground wire to the grounding stub.
4) Loop the wires |
| VALVE | |
|
| ||
throughtheheat |
| DESCRIPTION | |
shield. |
| ||
| 1) | Gas on/off knob | |
| 2) | Manual high/low adjustment | |
| 3) | Pilot Adjustment | |
5) Install the plastic bushing over the outside of | 4) | Thermocouple Connection | |
5) | Main Operator | ||
the hole to protect the wires from the sharp | 6) | Outlet Pressure Tap | |
edges. | 7) | Inlet Pressure Tap | |
8) | Pilot Outlet | ||
| |||
| 9) | Main Gas Outlet | |
| 10) | Flange Securing Screw Holes | |
| 11) | Alternative TC Connection Point | |
| 12) | Thermoelectric Unit | |
| 13) | Additional Valve Mounting Hole |
Before
6a) Attach the ground wire to the DC spark
mounting bracket.
6b) Next, attach the DC sparker generator wires
to the DC sparker.
DC spark generating wires
After
2)Loop the 2 DC Spark generating wires as well as the ground wire through the hole provided.
With Pedestal:
Select the hole to be used (depending on which side you prefer to install the DC Sparker box).
With Bottom Shield:
3)AttachthePiezo Ignition wire to the DC Sparker box.
ground wire | Piezo ignition wires |
7)InstallthesuppliedbatteryintotheDCSparker Box by opening the battery compartment.
NOTE: The battery in the DC Sparker Box will need to be replaced annually.
Battery
Compartment
8)Attach the heat shield to the DC Sparker, then mount onto either the Pedestal or the Bottom Shield, using the velcro already attached to the DC Sparker mounting bracket.
Note: We recommend attaching the DC sparker box to the bottom rear of the unit (away from the heat source). Ensure this a convenient location, easily accessible for battery replacement.
Regency® CLASSIC | 11 |
