INSTALLATION
SAFETY LATCH
Secure door in the closed position using the door securing bracket and the screw provided.
Note: Door securing bracket is there for safety.
Note: The door must be kept closed at all times, except during maintenance. The unit must never be operated without the glass in the door, or with the door open.
DOOR HANDLE
Attach spring handle by rotating counter clock- wise onto rod. Ensure that the spring fi ts into the entire length of the rod.
REMOTE CONTROL
INSTALLATION
Use the Regency® Remote Control Kit approved for this unit. Use of other systems may void your warranty.
The remote control kit comes with a hand held transmitter, a receiver and a wall mounting plate.
1)Choose a convenient location on the wall to install the receiver (protection from extreme heat is very important). Run wiresfrom the fi replace to that location. Use the Thermostat Wire Table.
2)Connect the two wires to the gas valve. See diagram below.
CAUTION
Do not wire the millivolt remote control wires to the 120V AC wires.
3)Install 3AAAalkaline batteries in transmitter and 4 AA alkaline batteries in the receiver. Install the receiver and its cover in the wall. Switch the remote receiver to "remote" mode. The remote control is now ready for operation.
REMOTE WALL
SWITCH
1)Run the wire through the opening in the rear of the unit. Be careful not to damage any wires.
Note: We recommend a maximum of 15' of wire but if you wish to go with a longer run use the Thermostat Wire Table.
2)Connect the wire to the wall switch and install into receptacle box.
CAUTION
Do not wire the millivolt wall switch for gas appliance to the 120V AC wires
WALL THERMOSTAT
INSTALLATION
Regency® offers an optional programmable thermostat but any
Connect the wires as per the wiring diagram. Use the Thermostat Wire Table to determine the maximum wire length.
CAUTION
Do not wire the millivolt wall ther- mostat wires to the 120V AC wires
Note: Preferableifthethermostatisinstalled on an interior wall.
Thermostat Wire Table
Recommended Maximum Lead Length
Thermostat
Wire Size | Max. Length | ||
14 GA. | 50 | Ft. | |
16 GA. | 32 | Ft. | |
18 GA. | 20 | Ft. | |
20 GA. | 12 | Ft. | |
22 GA. | 9 | Ft. | |
|
|
|
|
FINAL CHECK
Before leaving this unit with the customer, the installer must ensure that the appliance is fi ring correctly. This includes:
1)Clocking the appliance to ensure the cor- rect fi ring rate (rate noted on label) after 15 minutes.
2)Ifrequired,adjustingtheprimaryairtoensure that the fl ame does not carbon. First allow the unit to burn for 15 min. to stabilize.
3)Check for proper draft.
CAUTION: Any alteration to the product that causes sooting or carboning that results in damage to the unit is not the responsibility of the manufacturer and will not be covered by the warranty.
Regency® CLASSIC | 13 |
