INSTALLATION
GLASS CRYSTAL OR OPTIONAL CERAMIC STONES
INSTALLATION
Spread the supplied Glass Crystals (or optional Ceramic Spa Stones) evenly over the burner. Ensure the crystals (stones) do not overlap too much as this will effect the flame pattern.
NOTE: When installing, use either the supplied Glass Crystals or optional Ceramic Spa Stones - DO NOT combine the two when installing on Models P33S/ E33S/ L676S. Only the supplied approved Cobalt Blue Glass or optional Ceramic Spa Stones are to be used with this fireplace. Use of any other type of glass crystals or ceramic stones can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
NOTE: When using Ceramic Stones, DO NOT cover burner ports that lead to pilot flame.
Colbalt Glass Crystals/Ceramic Spa Stones Quantity
| Colbalt Crystals | Ceramic Spa Stones |
|
|
|
P33S | 1 bag | 70* |
|
|
|
E33S | 1 bag | 70 |
L676S | 1 bag | 70 |
*Recommended to use only 50 of the 70 ceramic stones on the P33S burner.
Glass Crystals shown on Burner
Optional Ceramic Stones shown on Burner
INSTALLATION
GLASS DOOR INSTALLATION
To install the glass door, simply hook the top door flange onto the top of the unit and swing the door towards the unit, (see Diagrams 1 and 2). Be careful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Refer to Diagram 3.
Secure door by fastening with two screws located at bottom of glass door, refer to Diagram 1.
Diagram 2
Screws
Diagram 1
Diagram 3
Regency® | 17 |