INSTALLATION
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
Rear Heat Deflector | Pedestal Assembly |
Assembly for F2400M | F2400M & S2400M |
|
|
All units require either the pedestal or 4 legs at- | The rear heat deflector is supplied with the stove | |
and must be installed unless the optional airmate | ||
tached to the base. The F2400M stove requires | ||
has been selected. It stops the heat radiated from | ||
either the Airmate or Rear Heat Deflector on top | ||
the flue collar from overheating the rear wall. The | ||
of the stove. Clearances to combustible materials | ||
rear heat deflector is installed on top of the rear | ||
vary depending on whether the airmate or rear | ||
heat shield, as shown in Diagram 4. | ||
heat deflector is installed, so be sure to check | ||
the Minimum Clearances, Installation section. |
|
1) For easier assembly, tip the stove on its |
back (onto a soft surface to prevent scratch- |
ing). |
Hint: If you have chosen the Ash Drawer |
option, remove the ash dump cover plates |
before attaching the pedestal. See page 17 |
"Ashdrawer Kit Installation". |
Airmate Assembly for F2400M
(850-105)
1)The airmate sits on top of the stove with the slots in the sides fitting over the curved deflector on the rear stove top. See diagram 1. Discard the Rear Heat Deflector that is supplied with the unit, it is not required if the airmate is installed.
2)Center the airmate and push it forward to the front of the stove. The back of the airmate should be level with the back and sides of the rear heat shield. See Diagrams 2 & 3.
Diagram 1
Diagram 2
Diagram 3
Diagram 4
S2400M Side Shield Adjustment
The left and right side shields are lowered for shipping and handling. It allows for a handhold on the top of the stove. Before placing in the Step Stove in its final position, the side shields must be raised.
Loosen the screws on the rear on the stove (3 per side), slide the side panel up as far as possible and then secure by tightening the screws.
2) Remove the blanking plate if | |
a) | you are not installing outside combustion |
b) | air or |
outside air is to be brought in from the | |
| rear of the stove. |
3) Unscrew the 4 bolts in the | |
stove. Align the holes in the corners of the | |
pedestal top with the corresponding holes | |
in the base of the stove. Fasten using a bolt | |
and washer for each corner. | |
4)Push the
Regency logo into the two holes in the front bottom left corner of the pedestal cover plate.
Note: Any paint touch up should be done prior to placing logo on pedestal.
5)If not using ash drawer, then cover plate must beinstalled.Ifusingashdrawer,thendisregard cover plate.
10 | Regency Freestanding Woodstove |
