Graco Inc ti9134b Installation, The sprayer requires, Fluid supply container follow local code

Installation

Installation

Grounding and Electric

Requirements

WARNING

Your system must be grounded. Read warnings, page 3.

The sprayer cord includes: a grounding wire with an appropriate grounding contact.

The sprayer requires:

110-120V Units: 100-130VAC, 50/60 Hz, 11A, 1 phase, circuit with a grounding receptacle.

240V Units: 210-255 VAC, 50/60 Hz, 7.5A, 1 phase, cir- cuit with a grounding receptacle.

Never use an outlet that is not grounded or an adapter.

Do not use the sprayer if the electrical cord has a dam- aged ground contact. Only use an extension cord with an undamaged ground contact.

Recommended extension cords for use with this sprayer:

•110-120V: 3-wire, 12 AWG (2.5 mm2) minimum, 300 ft. (90 m) maximum length.

•240V: 3-wire, 16 AWG (1.0 mm2) minimum, 300 ft (90 m) maximum length.

Smaller gauge or longer extension cords may reduce sprayer performance.

Spray gun: ground through connection to a properly grounded fluid hose and pump.

Fluid supply container: follow local code.

Solvent and Oil-based fluids: follow local code. Use only conductive metal pails placed on a grounded sur- face such as concrete. Do not place the pail on a non- conductive surface such as paper or cardboard, which interrupts grounding continuity.

Grounding the metal pail: connect a ground wire to the pail by clamping one end to pail and other end to ground such as a water pipe.

To maintain grounding continuity when flushing or relieving pressure: hold metal part of the spray gun firmly to the side of a grounded metal pail, then trigger the gun.

310824D 7