Gas Fireplaces
FPI Direct Vent System (Flex)
Horizontal Terminations Only
These venting systems, in combination with the P36 / P36D Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram.
FPI Direct Vent (Flex) System Termination Kits include all the parts needed to install the P36 / P36D using a flexible vent.
FPI Kit # | Length | Contains: | ||
4 Feet | 1) | |||
|
| 2) | 4” fl exible liner (Kit length) | |
|
| 3) | spring spacers (3) | |
|
| 4) | thimble (2) | |
|
| 5) | AstroCap termination cap (1) | |
10 Feet | ||||
6) | screws (12) | |||
|
| 7) | tube of Mill Pac (1) | |
|
| 8) | plated screws (8) | |
|
| 9) | S.S. screws #8 x |
Notes:
1)Liner sections should be continuous without any joints or seams.
2)Only Flex pipe purchased from Regency may be used for Flex installations.
3)Horizontal sections must be supported every 3 feet.
Wall Thimble (2 pc)
4" (102mm) | AstroCap |
dia. flue pipe | Termination Cap |
| Part |
|
(173mm) dia. | spring | Alternate Horizontal |
Flue pipe | spacer | Termination Caps |
|
Alternate:
Horizontal
Riser Vent
Terminal
Part#
If required by the external termination location the listed alternate termination caps may be used. (Refer to Page 11)
June 2007 Regency Product Specifications Book
P36 - P36D Gas Fireplace
Snorkel Terminations
Snorkel Terminations:
For installations requiring a vertical rise on the exterior of the building,
Below Grade Snorkel Installation
If the Snorkel Termination must be installed below grade, i.e. basement application, proper drainage must be provided to prevent water from entering the Snorkel Termination. Refer to Rigid Pipe Installation instructions for details. Do not attempt to enclose the Snorkel within the wall, or any other type of enclosure.
37
Gas Fireplaces