8 Chapter 4: Trimmer Operation
4.Remove the line retaining ring from the spool (see Figure
5.Measure out 30 feet of replacement line.
6.Push one end of the new line through the left line mounting hole on the spool (see Figure
7.Feed 15 feet of the line through this hole. Feed the other 15 feet of line through the right line mounting hole (see Figure
8.Lay the line from the left mounting hole into the upper spool section. Lay the line from the right mounting hole across the other line.Insert this line into the retaining slot between the upper and lower spool section, then lay the line into the lower spool section. See Figure
9.Place the line from the upper spool section through the line retaining ring (see Figure
10.Place the line retaining ring back on the spool (see Figure
Direction of
Line Feed
Line Retaining
Ring
| Retaining |
Figure | Slot |
|
Figure
Figure
Direction of
Line Feed
Direction of
Line Feed
Figure
Figure
Figure
118336