Remington ST3010A owner manual trimmer assembly, Assembling Trimmer, Attaching Cutting Guard

4

3 trimmer assembly

Assembling Trimmer

WARNING: Do not operate trimmer without guard or handle in place.

Attaching Cutting Guard

1.Remove three mounting screws taped to underside of cutting guard.

2.Align key tabs on inside of cutting guard hole with cutouts on motor housing and slide cutting guard over cutting head (see Figure 3-1). Slip cutting guard past the tabs.

3.Rotate guard 90° until it stops (see Figure 3-2).

4. Insert one mounting screw into center	Figure 3-1: Placing cutting guard over cutting head	Figure 3-3: Attaching mounting screw
screw hole at top of cutting guard (see
Figure 3-3). Tighten screw firmly.

Figure 3-2: Rotating cutting guard into place

118336