Remington ST3812B, ST4514B owner manual Arranging line into spool

10 Chapter 4: Trimmer/Edger Operation

8.Lay the line from the left mounting hole into the upper spool section. Lay the line from the right mounting hole across the other line. Insert this line into the retaining slot between the upper and lower spool section, then lay the line into the lower spool sec- tion. See Figure 4-20 for proper line placement.

9.Place the line from the upper spool section through the line retaining ring (see Figure 4-21).

10.Place the line retaining ring back on the spool (see Figure 4-22).

11.Position each line section in the slots on either side of the retaining ring (see Figure 4-23).

12.Hold the retaining ring in place and make sure the line remains in the retaining ring slots. Rotate the spool while holding the retain- ing ring in place. The line will roll onto the spool (see Figure 4-24). IMPORTANT: Make sure to rotate the spool so the line winds onto spool in the direction indicated on the spool top. Wind line until four inches of line remains outside the spool.

13.Replace spool onto spool spring and press spool down. Lay exposed trim- mer/edger line into slots on spool housing (see Figure 4-25).

14.Align tabs on spool cover with slots in spool housing. Replace spool cover onto spool housing and snap into place (see Figure 4-26).

Retaining

Slot

Figure 4-20: Arranging line into spool

Figure 4-22: Placing retaining ring onto spool

Figure 4-21: Placing upper spool line into retaining ring

Lines Through Slots in Retaining Ring

Figure 4-23: Positioning line in retaining ring slots

118035