24
3.4.5 Connection Type
Select whether the connection is for Boot Mode or User Mode in the ‘Connection Type’ dialog.
Additionally, for a connection to a kernel that is still running on the device from a previous session, select
the ‘Kernel already running’ check box. Next, select the communication speed (bps) if the default valu e is
not correct or not present. Speeds where the target er ror rate is greater than 4%, or the FDM\E8Direct e rror
rate is greater than 0% are automatically removed from the recommended list. When using the
FDM\E8Direct the ‘User Specified’ connection speed option is enabled; when selected, this allows the user
to specify a non-standard baud rate. The error rate will be displayed – this takes into account the target
peripheral clock rate, the target Bit Rate Register calculation formula, and the FDM\E8Direct
characteristics.
Click the ‘Next’ button to continue.
Figure 3-6 Connection Type
Note that ‘Use Default’ is designed for use with the Renesa s Evaluation Board or Evaluation Development
Kits. Uncheck this to allow manual selection of the bit rate.