STOPPING YOUR TREATMENT
To stop your treatment at any time, remove your mask and press the Start/Stop key. Alternatively, if your flow generator has the SmartStart function available, simply remove your mask and treatment will end.
Some flow generators continue to blow air gently after you have stopped your treatment. This can continue for up to one hour to assist the heater plate in cooling. However, you can unplug the device from the power outlet at any time and allow the heater plate to cool without airflow.
DETACHING YOUR HUMIDAIRE 3i
Please refer to the illustrations in section G of the illustration sheet.
1Unplug the power cord from the power outlet
WARNING
! Take care when handling your HumidAire 3i. The water and the water chamber base may both be hot. Allow ten minutes for the heater plate and any excess water to cool
2Remove the water chamber from the docking station
3Press the large silver button located midway underneath the docking station
Large silver button
UNDERSIDE VIEW
Note:
ENGLISH
FREQUENTLY ASKED QUESTIONS
WHY IS THERE CONDENSATION IN MY MASK AND/OR AIR TUBING?
You may experience excessive condensation in your mask or air tubing. This may occur seasonally, particularly when the room temperature is low or cool air is circulating around the tube. Turn the control dial down to a lower setting until the condensation decreases.
You may have to adjust your humidity setting from season to season.
DO I HAVE TO USE DISTILLED WATER IN THE WATER CHAMBER?
Using distilled water will maximize the life of the water chamber and reduce mineral deposits. See “Cleaning your HumidAire 3i” on page 11 for further details.
FREQUENTLY ASKED QUESTIONS | 9 |