ResMed 3I user manual Reassemble the parts when they are clean and dry

COVER AND COVER SEAL

Inspect the cover and cover seal weekly for wear and deterioration. Replace any damaged parts. When required, wash the cover and cover seal in warm water, using a mild detergent (see previous caution). Rinse them thoroughly with clean water and allow them to dry away from direct sunlight.

DOCKING STATION

Periodically wipe the outside of the docking station (including the connector seal) with a damp cloth.

REASSEMBLING YOUR HUMIDAIRE 3i

Please refer to the illustrations in section I of the illustration sheet.

Reassemble the parts when they are clean and dry.

1Align the cover seal to the guides on the cover (I-1)and press along the edges to ensure it is fitted properly (I-2).

2Put one cover arm into its pivot point on the docking station (I-3)and gently flex the other arm into its corresponding point (I-4 & I-5).

The cover should be able to open and close freely while securely attached to the docking station.

3Replace the water chamber in the humidifier docking station (I-6).

SERVICING

With normal use of a HUMIDAIRE 3i, the water chamber needs to be replaced every two years.

This product (HUMIDAIRE 3i) should be inspected by an authorized ResMed Service Center 5 years from the date of manufacture. Prior to this, the device is intended to provide safe and reliable operation provided that it is operated and maintained in accordance with the instructions provided by ResMed. Applicable ResMed warranty details are provided with the device at the time of original supply. Of course, as with all electrical devices, if any irregularity becomes apparent, you should exercise caution and have the device inspected by an authorized ResMed Service Center.

12