Manuals / Brands / Kitchen Appliance / Ventilation Hood / ResMed / Kitchen Appliance / Ventilation Hood

ResMed Stellar 100 and 150, Stellar 100, Stellar 150 Starting therapy using oxygen, Stopping therapy using oxygen, Using the FiO2 monitoring sensor

1 40

Download 40 pages, 7.67 Mb

Starting therapy using oxygen

1Fit the oxygen connector to the oxygen inlet of the device.

2Attach the other end of the oxygen supply tubing to the oxygen supply.

3 Press to start treatment.

4Turn on oxygen.

Stopping therapy using oxygen

1Turn off oxygen.

2Press to stop treatment.

Using the FiO2 monitoring sensor

Use of the FiO2 monitoring sensor may be recommended by your clinician.

CAUTION

Do not use the FiO2 monitoring sensor with the H4i humidifier.

Preparing to use a new sensor

1Before use, leave the FiO2 monitoring sensor open to the air for 15 minutes.

2Attach a new FiO2 monitoring sensor (as shown below).

3Perform the sensor calibration (see “Setup menu” on page 16).

Note: The FiO2 monitoring sensor must be replaced every 12 months.

Oxygen

supply

Press spring to release

connection after use

Contents

Main Page i Contents Introduction Stellar at a glance Setting up for noninvasive use Setting up for invasive use Working with other optional accessories Page 1Introduction Introduction Indications for use Contraindications Adverse effects Stellar at a glance 3Stellar at a glance Patient interface Humidification Internal battery Maintenance 1 Setting up for noninvasive use 1 2 3 2 34 5Setting up for invasive use 4 5 6 7 Setting up for invasive use Page 7Working with other optional accessories Working with other optional accessories Attaching the pulse oximeter Contraindication 1 2 Adding supplemental oxygen Starting therapy using oxygen Stopping therapy using oxygen Using the FiO2 monitoring sensor Attaching an antibacterial filter Stellar basics About the control panel 11Starting therapy LCD screen Starting therapy Performing a functional test 1 2 3 4 Starting therapy 1 2 3 Stopping therapy 13Starting therapy Turning off the power 1 2 Working with alarms 14 Tailoring treatment setup options Setting Ramp Programs Using mask-fit 1 2 3 Using the menus Note: iVAPS mode is only available in Stellar 150. Setup menu Setup menu: Clinical Settings (Mask Type) Setup menu: Alarm Settings (Alarm Volume) Setup menu: Options Setup menu: Configuration Menu 17Setup menu Info menu Event Summary Used Hours Device Information Reminders Data management 1 2 3 Cleaning and maintenance Weekly Monthly Replacing the air filter 21Cleaning and maintenance Disinfection Multipatient use Servicing Troubleshooting Alarm troubleshooting 23Troubleshooting Page Other troubleshooting 25Troubleshooting Page Technical specifications 27Technical specifications Page 29Technical specifications Guidance and manufacturers declaration electromagnetic emissions and immunity Page 31Technical specifications Symbols 32 General warnings and cautions WARNINGS CAUTIONS Page Limited warranty