Manuals / Brands / Baby / Model Vehicle / RF-Link Technology / Baby / Model Vehicle

RF-Link Technology Network Communications Module, RFL NCM - page 42

1 52

NOTE

When using binary numbers with a SET command, they must be preceded by the letter “B” as

shown in the following example:

<MULTIPLEXER ADDRESS>:<CARD ADDRESS>:SET:P1 = B00000011;

Besides using the P code, it is also possible to turn module service on or off by sending one of the

following in the parameter field with a SET command:

SRVC = ON

SRVC = OFF

RFL NCM RFL Electronics Inc.

November 6, 2007 42 (973) 334-3100

Contents

Main RFL NCM Network Communications Module DESCRIPTION SPECIFICATIONS Page Page Page Page Page Page Page Page Page RFL NCM RFL Electronics Inc. November 6, 2007 12 (973) 334-3100 Table 1. Controls and indicators, RFL NCM Module Page RFL NCM RFL Electronics Inc. November 6, 2007 14 (973) 334-3100 Note: Refer to Table 2 for additional switch setting information. Page Page Page Page Page FUNCTIONAL DESCRIPTION Page Page Page Page Page Page TESTING TEST EQUIPMENT REQUIRED LOOP TEST PROCEDURE FOR RFL NCM MODULES IN NMS MODE INSTALLED IN TERMINAL MULTIPLEXERS Page LOOP TEST PROCEDURE FOR RFL NCM MODULES IN NMS MODE INSTALLED IN DI-A CONFIGURED MULTIPLEXERS Page LOOP TEST PROCEDURE FOR RFL NCM MODULES IN NMS MODE INSTALLED IN DI-B CONFIGURED MULTIPLEXERS Page Page Page Figure 13a. Typical 3-node network using MA-485s (1 RS-485 port) Figure 13c. Typical 3-node network using MA-402Is (2 RS-232 ports) Figure 13b. Typical 3-node network using MA-490s (1 RS-232 port, and 1 Ethernet port) Page Page Page Page Page P CODES Page Page Page Page S CODES Page Page Page Page Page NOTICE RFL Electronics Inc.