Rheem ECO-180DV, P), PH-25RDVS, RUTG-66DV, RMTG-66DV warranty Remote Control Installation

WARNING: Field wiring connections and electrical grounding must comply with local codes, or in the absence of local codes, with the latest edition of the National Electrical Code, ANSI/NFPA 70, or in Canada, Canadian Electrical Code, CSA C22.1 Part 1.

NOTICE: The provided remote control will allow a maximum temperature setting of 120°F (49°C).

Temperatures of up to 140°F (60°C) can be achieved with the MAIN (UMC-117) remote control. Only qualified service personnel should perform this adjustment.

Notice: An optional cable (EZ Link Cable™) can be purchased separately to manifold two heaters together.

Remote Control Installation

One (1) remote control is provided with the water heater.. Additional remote controls may be purchased separately.. Up to three (3) remote controls can be used with this water heater..

The following are considerations for determining the location of the remote control(s):

●DO NOT install any remote control outdoors or in areas where it can come in contact with water..

●Place remote control out of children’s reach..

●The remote control can be installed in convenient locations such as the kitchen, laundry room, utility room, or directly beside the water heater..

●Avoid areas where the remote control may be exposed to heat, e..g.. ranges or heaters..

●Avoid areas where the remote control

may be subjected to oil and/or steam from cooking..

●Avoid areas where chemical agents (such as thinner, benzine and alkalines) are used..

●Avoid areas of direct sunlight..

●The MAXIMUM distance between the water heater and the remote control installation location is limited to 195 feet (59 m) of wire..

NOTICE: Only one of each type of remote controls can connect to the water heater. Therefore, a maximum of three controls can connect to the water heater.

No other manufacturer’s controls are suitable for use with this water heater.

DO NOT attempt to disassemble the remote control.

MAIN

Base Plate

Remote	Remote	Temperature
Control
	Control	Set Point	Availability
Model
	Description	Range
Number

Control

PRIORITY

°F

PO	R
	WEF
ON/OF

Mounting Screw x 2

Control screw

NOTICE: If a manifold system is installed, the main remote control connected to the manifold controller (MIC-180) has priority over the remote controls connected to the water heater..

		100°F–120°F	Optional (Sold
		(38°C)–(49°C)
USC1-117	BATH 1		Separately)
		85°F (29°C)	Qualified Technician
			Adjustment
		100°F–120°F	Optional (Sold
USC2-117	BATH 2	(38°C)–(49°C)	Separately)
		85°F (29°C)	Qualified Technician
			Adjustment
		100°F–120°F	Factory Default
		(38°C)–(49°C)
UMC-117	MAIN
		85°F (29°C)	Qualified Technician
		125°F–140°F
			Adjustment
		(52°C)–(60°C)
MIC-180	Manifold		Optional (Sold
Manifold	System		Separately)
System

19