Rhino Mounts SE4 manual Assembly

MAINTENANCE

MAINTENANCE

DISASSEMBLY OUTPUT SHAFT (FIG Mnt-R-0042)

1.Install slotted nut (Ref 18, Mnt-R-0040) onto shaft and then tap shaft end on solid surface to remove lower bearing and spacer.

2.Remove snap ring (Ref #7) and then repeat above procedure to remove upper bearing.

ASSEMBLY

1.Assembly of output shaft is accomplished in exact reverse order. Install bearing over shaft and press up against bottom end of gear. Install snap ring (Ref. #7 Mnt-R-0040).

2.Install spacer and lower bearing on shaft. NOTE: Bearing Spacer (Ref #6) may be two different lengths and each spacer requires a different bottom cap.

LOWER BEARING RETAINER CAP (Figure Mnt-R-0043)

1.Remove old seal from cap and press in new seal. (See SEAL INSTALLATION RECOMMENDATIONS).

Note difference between bearing caps shown to make sure proper part is being used.\

SE4 05/05 Maintenance Section 5-10

© 2005 Alamo Group Inc.