ASSEMBLY
A-FRAME INSTALLATION (FIGURE AsmP-R-0017)
1.Attach “A” Frames (1) to inside of welded hitch brackets on Mainframe, insert Hitch Pin (12), Bushing (15), flat- washer (11), lockwasher (14) and install nut (13). Then attach to lug hitch with bolt (22) and locknut (23).
2.Install the lift straps (3) on inside of top rails on mainshield (behind gearbox mount) and attach with 1/2" x
3.Insert spacer (7) between A- frames (1). Insert 3/4" x 6" bolts (8) thru hole in lift straps and spacer (7). Secure with 3/4" locknut (9).
TAIL WHEEL INSTALLATION (FIGURE 5)
4.Align tailwheel beam weldment (16) between pivot brackets located behind gearbox mount on mainshield weldment. NOTE: Long side of caster fork pivot tube is positioned up. Attach tailwheel beam weldment to mainshield with 5/8" x
5.Insert caster fork assembly (19) into tailwheel beam weldment (16). Install washer
(17)and secure with cotter pin (18).
6.Place tailwheel adjusting brackets on to deck and secure with bolt (20) and locknut
7.Position tailwheel beam weldment between tailwheel adjusting brackets on mainshield weldment and secure with two 1/2" x 3" bolts (8) and locknut (9).
8.Tighten all bolts to the proper torque.
SE4 05/05 | Assembly Section |
© 2005 Alamo Group Inc.
