
ASSEMBLY
ASSEMBLY
TAIL WHEEL ASSEMBLY - LIFT TYPE
.
1.Attach Beam Support Weldments (2) to the Main Frame Assembly with 1/2 x
(6)& Locknuts(7).
2.Slide the Beam Weldment (1) through Bracket
(3)and attach to the Cutter Lugs with 5/8 x 4- 1/2 Bolt(4) and Locknut(5).
3.Remove cotter pin(18) and one washer(21) fromfork pivot shaft. Insert shaft into tube on end of beam. Reinstall flat washer (21) and cotter pin (18).
4.Install 1/2 x
The Components of these machines are quite heavy. Block all components up securely before working under or putting extremities under such parts.
TONGUE - PULL TYPE
Insert tongue lugs inside mainframe uprights and retain using Bushings
AXLE ASSEMBLY - PULL TYPE
Attach the Rear Axle to the lugs on the rear of the Mainframe using (3) 3/4 x 3 bolts (#1) bushings
TW144 01/11 | Assembly Section |
© 2011 Alamo Group Inc.