Rhino Mounts TW144 manual Main CV Driveline Safety Shield Figure Mnt-R-0032

MAINTENANCE

MAINTENANCE

MAIN CV DRIVELINE SAFETY SHIELD (FIGURE Mnt-R-0032)

To remove the outer CV cone, remove the locking screws from shield cone. Remove cone over yoke. MNT-R- 0038. Remove bearing ring and remove the locking screws from inner shield cone. Mnt-R-0038.Turn inner cone to assembly position and remove half shield. Remove bearing ring. MNT-R-0038.

To assemble outer CV driveline, grease yoke groove and inner profile tube. Attach bearing ring on groove with recesses facing profile tube. Slide on half shield with cone. Turn cone until it engages correctly. Tighten locking screws. Grease bearing groove in double yoke. Insert bearing ring. Slide guard cone for double yoke over cam from the connecting end. Make sure holes for screws are visible. Tighten locking screws. MNT-R-0039

Important! Check

that Guard Missing decal on steel tube under inner guard and Rotating Driveline Decal are firmly affixed, undamaged and readable. If not, replace.

TW144 01/11 Maintenance Section 5-10

©2011 Alamo Group