Chapter 11

11 - 2

Document Jam The document was not inserted or fed
properly, or the document scanned from
the ADF was too long.
See Document jams on page 11-4.
See Using the automatic document feeder (ADF) on
page 1-8.
Drum Error The drum unit needs to be cleaned. See Cleaning the corona wire on page 11-21.
DR Mode in Use The machine is set to Distinctive Ring
mode. You can not change the Receive
Mode from Manual to another mode.
Set Distinctive Ring to Off.
See Turning off the Distinctive Ring on page A-3.
Fail to Warm up The fuser unit is too cold. Turn off the machine’s power switch, and check the
machine’s environment. If it is in a location that is too
hot or too cold, try to cool or warm the room by turning
on the air conditioner or heater. Or, change the
location. Then, turn on the machine’s power switch.
(The machine can be disconnected for up to 4 days
without losing faxes stored in the memory.)
Unit is too Hot The fuser unit is too hot.
Machine too Hot The inside of the machine is too hot. Listen to the machine to check that the cooling fan is
spinning.
Make sure that the air vents are not covered up or
blocked.
If the fan is spinning and air vents are clear, you should
let the machine cool down for several minutes before
using it again.
If the fan is not spinning, follow the suggestions below.
Turn off the machine's power switch and then on
again. If the error message continues leave the
machine for several minutes and then try it again. (The
machine can be turned off for up to 4 days without
losing faxes stored in the memory.)
No cartridge The toner cartridge and drum unit
assembly is not installed or is not
installed properly.
Reinstall the toner cartridge.
No Paper Fed The machine is out of paper or paper is
not properly loaded in the paper tray.
Refill the paper in the paper tray and then press
Start.
OR
Remove the paper and load it again and then press
Start.
No Response/Busy
The number you dialled does not
answer or is busy.
Verify the number and try again.
Not Registered You tried to access a One-Touch or
Speed Dial number that is not
programmed.
Set up the One-Touch or Speed Dial number.
(See Storing One-Touch numbers on page 5-1 and
Storing Speed-Dial numbers on page 5-2.)
ERROR MESSAGES
ERROR MESSAGE CAUSE ACTION