Reset mode | Ricoh FV-G200B1 specification

3.5H reset mode

In this mode, the exposure can be start during the video is out from the camera without the horizontal noises. Therefore, generates the SUB pulse to sweep the charges during the horizontal blanking to prevent from getting horizontal noises.

The image is getting the horizontal noises caused by generates the SUB pulse during the video out in normal mode, which is this mode is OFF.

The maximum delay to start exposure from the trigger input is 1H.

Trigger signal (Rising edge）

Next HD

Internal HD

Normal SUB pulse timing

SUB pulse

CCD exposure		Noise
CCD exposure

Video out

	FV-G200B1	17/38
	User’s Guide Rev. 1.02	17/38
	User’s Guide Rev. 1.02

Image 17

Ricoh FV-G200B1 manual Reset mode

Contents

FV-G200B1 User’s Guide Rev GigE Vision VGA Monochrome CCD Camera FV-G200B1 Table of Contents RJ45 Connector Connector Specifications Power-I/O Connector DC Iris Lens Connector FV-G200B1 User’s Guide Rev Or equivalent connector Equivalent Circuit for the Input Pin of the I/O Connector Vertical Timing Full Scanning Horizontal Timing 3 1/4 Partial Scanning 2 1/2 Partial Scanning Fval Lval SUB AOI Area of Interest Pixel Transferring Image Timing Normal ModePulse Width Trigger Mode Input Trigger signal Exposure Timing with the Positive Polarity Trigger SignalTrigger signal Trigger signal With Photocoupler delay Edge Preset Trigger Mode 14/38 15/38 16/38 Reset mode Communication Format Communication SettingsCommunication Method Name Descriptions 【Example Code】Reading the data from the command 00H Camera Command List Device Code Camera Control Command 22/38 23/38 24/38 Underline settings are the factory default settings Descriptions of the Camera Control Commands Device code 26/38 27/38 28/38 29/38 30/38 AGC Descriptions of the Camera Commands Device code 32/38 33/38 34/38 GenICam command Device Command Function GenICam Command / Camera Command Reference Table 2EH 37/38 38/38