37/38 | Ricoh FV-G200B1 specification

Caution:

Width, Height and PixelFormat all affect the image data size.

Please use command name defined by GenICam when changing these values, as exampled in the following sample code.

In the case to change the Width

BOOL SetWidth( PvDevice *pDevice, PvInt64 lValue )

{

PvGenInteger* lGenInteger = dynamic_cast<PvGenInteger*>( pDevice->GetGenParameters()->Get( "Width" ) ); PvResult lResult = lGenInteger->SetValue(lValue);

return lResult.IsOK();

}

	FV-G200B1	37/38
	User’s Guide Rev. 1.02	37/38
	User’s Guide Rev. 1.02

Image 37

Ricoh FV-G200B1 manual 37/38

Contents

FV-G200B1 User’s Guide Rev GigE Vision VGA Monochrome CCD Camera FV-G200B1 Table of Contents RJ45 Connector Connector Specifications Power-I/O Connector DC Iris Lens Connector FV-G200B1 User’s Guide Rev Or equivalent connector Equivalent Circuit for the Input Pin of the I/O Connector Vertical Timing Full Scanning Horizontal Timing 3 1/4 Partial Scanning 2 1/2 Partial Scanning Fval Lval SUB AOI Area of Interest Pixel Transferring Image Pulse Width Trigger Mode Normal ModeTiming Input Trigger signal Exposure Timing with the Positive Polarity Trigger SignalTrigger signal Trigger signal With Photocoupler delay Edge Preset Trigger Mode 14/38 15/38 16/38 Reset mode Communication Method Communication SettingsCommunication Format Name Descriptions 【Example Code】Reading the data from the command 00H Camera Command List Device Code Camera Control Command 22/38 23/38 24/38 Underline settings are the factory default settings Descriptions of the Camera Control Commands Device code 26/38 27/38 28/38 29/38 30/38 AGC Descriptions of the Camera Commands Device code 32/38 33/38 34/38 GenICam command Device Command Function GenICam Command / Camera Command Reference Table 2EH 37/38 38/38