Installation

Powering On/Off the Projector

Powering On the Projector

1.Ensure that the power cord and signal cable are securely connected. The Power indicator will turn red.

2.Remove the lens cap.

3.Turn on the lamp by pressing “Power” on the control panel or the remote control. The Power indicator will flash blue. The startup screen will display in approximately 5 seconds.

After the screen disappears, the Power indicator will turn blue.

The first time you use the projector after purchase, the lan- guage menu is displayed after the startup screen.

(See pages 34~35)

4.Turn on your source (computer, notebook, video player, etc.) The projector will detect your source automatically.

Note

If you connect multiple sources at the same time, use the “Input” on the remote control or use “Com- puter 1”, “Video”, “S-Video”, “HDMI” on the remote control to switch inputs.

Note

Turn on the projector first and then the signal sources.

CAUTION:

•Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyesight.

•Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

•Do not place your hands, face, or other objects near the air exhaust, the lamp cover or the bottom of the unit. Doing so could result in injury and/or damage the object.

•Do not block the light from projection lens by anything when you want to stop projection. Doing so could cause a fire due to heating by strong light. Please use

“AV Mute” function for this purpose.

2 Power

OR

Lens Cap

1

22

English