Appendices
Replacing the lamp
Warning: To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp!
The projector will detect the lamp life itself. It will show you a warning message
When you see this message, change the lamp as soon as pos- sible. Make sure the projector has been cooled down for at least 60 minutes before changing the lamp.
2
1
3
Warning: To avoid the risk of personal injury, do not drop the lamp module or touch the glass parts. The glass parts may shatter and cause injury if it is dropped.
Warning: For continued safety replace with a lamp of the same type.
Caution: If the lamp should break, handle with care to avoid injury due to broken pieces and contact your sales representative for repair service.
4
1.Switch off the power to the projector by pressing the “Power”.
2.Allow the projector to cool down at least 60 minutes.
3.Disconnect the power cord.
4.Use a screwdriver to remove the 2 screws from the cover.
5.Push up and remove the lamp cover.
6.Loosen the 2 screws from the lamp module and pull up the lamp bar.
7.Pull out the lamp module by force.
8.Install the new lamp module by reversing the previous steps.
See the lamp’s manual for instructions on resetting the lamp time.
Used Lamps
This projector’s lamp contains trace amounts of environmentally
harmful inorganic mercury. Be careful not to break used lamps, |
|
and dispose of them in accordance with local regulations or con- |
|
tact your sales representative. | 45 |
English
English