RIDGID 120V manual Operation, Powering the System, Age its pins. Twist only the locking sleeve

Black and White Monitor+VCR, Color Monitor+VCR

Figure 5 – Completely Closing the Top Door

NOTE! The lower door must be closed before the top door is closed.

Operation

Powering the System

1.Locate the power cord on the back of the unit. Unhook the Velcro strap and remove the plug from the holder. (Figure 6)

NOTE! The outlet inside the cord wrap is not an active plug. It is the holder for the GFCI plug.

Figure 6 – Power Cord and Cord Wrap

2.Plug the Monitor+VCR’s power cord into an approved outlet. Press the reset button on the GFCI. (Figure 7)

NOTE! You must press the reset button every time you plug the unit in.

Press Reset

Button

for Power

Figure 7 – Ground Fault Circuit Interrupter (GFCI)

3.Unwrap the SeeSnake systems cable from its storage hooks on the SeeSnake or Mini-SeeSnake frame. (Figure 8)

NOTE! Never twist the connector body or you may dam-

age its pins. Twist only the locking sleeve.

4.Plug the systems cable into the mating connector on the Monitor+VCR power supply (connector for SeeSnake Systems Cable). Orient the systems cable male connector by locating the “TOP” label and adjust in UPWARD position (Figure 9). Make sure the guide pin on the systems cable is properly aligned into the guide socket on Monitor+VCR’s connector. This guide pin is on the top of the connector. When joining these connectors, make sure you push straight in until fully seated and then screw down the locking sleeve. Figure 10 shows a close-up of the joining connectors. Figure 11 shows connector functions.

SeeSnake

System Cable

Figure 8 – SeeSnake Systems Cable

Ridge Tool Company 7