![](/images/new-backgrounds/1314741/31474145x1.webp)
Cutter Knife Sharpening
The knives can be honed individually with an ordinary oil- stone.
Make sure your oilstone is not worn in the center. It must be flat.
Be sure to remove the burr on the flat side.
WARNING: The cutter knives are extremely sharp. Do not let your hand or fingers touch the cutter knives.
If the knives are nicked they must be replaced or reground. They can be reground several times until they become 9/16" wide. Never install unbalanced knives or reground knives less than 9/16" wide.
Have your knives reground by someone who is compe- tent. Look under “Sharpening Services” in the “Yellow Pages” of your telephone directory.
NOTE: The knives may have a second, very small ground surface very close to the sharpened edge of the blade. Hone only the edge of the blade which will be doing the cutting.
38°
11/16 In
Wide
New Blade
| Second | |
Cutting | Ground | |
Surface | ||
Edge | ||
|
23