Apprendre à connaître votre compresseur d’air
Operating Your Air Compressor
2 Manomètre Réglé | 3 Poignée | 4 Bouton de |
| ||
de Sortie d’Air |
| Régulateur |
|
| 5 Manomètre |
1 Réservoirs de |
| du Réservoir |
stockage d’air |
|
|
|
| 6 Soupape |
|
| de Sûreté |
|
| ASME |
Moisture in compressed air will form into droplets as it comes from an air compressor pump. When humidity is high or when a compressor is in continuous use for an extended period of time, this moisture will collect in the tank. When using a paint spray or sandblast gun, this water will be carried from the tank through the hose, and out of the gun as droplets mixed with the spray material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when spraying other than water based paints. If sandblasting, it will cause the sand to cake and clog the gun, rendering it ineffective.
A filter in the air line, located as near to the gun as possible, will help eliminate this moisture.
7 Raccords de |
sortie d’air |
8Compresseur
9 Interrupteur Marche/Arrêt
Make sure the tank drain valve is closed, the regulator knob is turned fully counter- clockwise, and the On/Off switch is in the OFF position.
Plug compressor into a dedicated 15 Amp (minimum) circuit.
Turn On/Off switch to the ON position. The compressor will now start building pressure.
After compressor reaches
Adjust the regulator knob to the desired pressure.
The compressor is now ready to operate.
!WARNING:
Do not
10 Robinet de vidange du réservoir
XXXXXXX
ridgid.com
Décalque de modèle
1.Read instructions: Carefully read through this operator’s manual BEFORE OPERATING the new air compressor. It contains information about operation and maintenance of the unit.
2.Drain tank daily: Depressurize system prior to draining tank. Open tank drain valve and drain moisture from tank. This helps keep oil and mois- ture out of the compressed air sys- tem. Be sure to close tank drain valve tightly before operating compressor.
Fr 12 | 13 |