Safety Instructions (continued)

Pièces de rechange

8.Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).

9.Wiring and fuses should follow electrical codes, current capacity, and be properly grounded.

10.Electric motors must be securely and adequately grounded. See grounding instructions and extension cord information in this manual.

11.Always disconnect power source before working on or near a motor, or its connected load. If power disconnect point is out-of-sight, lock it in the open position and tag to prevent unexpected application of power.

12.Guard all moving parts; keep visitors away. Never allow children in work area.

13.Use only a properly grounded outlet that will accept a three pronged plug, and wear shoes to prevent shock hazards.

14.Be careful when touching exterior of operating motor; it may be hot enough to cause injury.

15.Protect power cable from coming in contact with sharp objects.

16.Clean electrical or electronic equipment with an approved cleaning agent, such as dry, nonflammable cleaning solvent.

17.To avoid spontaneous combustion, discard waste rags into approved metal waste cans.

18.Never store flammable liquids or gases in vicinity of compressor.

19.When spraying with solvent of toxic chemicals, follow instructions provided by the chemical manufacturer.

20.Spray in a well ventilated area, to keep fumes from collecting and causing health and fire hazards.

21.Do not spray in vicinity of open flames or other places where a spark can cause ignition. Do not smoke when spraying paint, insecticides, or other flammable substances.

22.Use a respirator when spraying.

23.NEVER reset safety valve or pressure switch. Keep safety valve free from paint and other accumulations. This provides safety against over pressure.

24.Do regular maintenance; keep all nuts, bolts, and screws tight, to be sure equipment is in safe working condition.

25.Keep cleaning rags and other flammable waste materials in a tightly closed metal container and dispose of later in the proper fashion.

26.Drain tanks of moisture after each day’s use. If unit will not be used for a while, it is best to leave drain cock open until such time as it is to be used. This will allow moisture to completely drain out and help prevent corrosion of inside of tank.

27.Inspect tank yearly for pin holes or any other imperfections that could cause it to become unsafe. NEVER weld or drill holes in air tank.

28.This product is not intended for installation or use in a commercial garage or the like.

41

36

37

38

39

40

 

 

 

13

 

 

 

 

 

 

15

 

14

 

 

 

 

 

 

 

 

 

 

 

 

 

 

17

 

 

 

16

 

 

 

 

18

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

19

20

 

 

 

 

 

21

 

 

 

 

 

 

 

22

 

 

 

 

4

5

6

24

 

23

 

 

 

 

 

25

27

28

2

1

 

 

 

26

7

 

 

 

 

3

 

 

 

 

 

 

 

31

30

 

 

 

 

8

 

 

 

 

 

 

 

 

 

9

10

 

 

 

32

 

11

 

29

34

 

35

33

12

 

 

 

 

4

Fr 21