SP6567 16 Gallon Steel.qxd 8/15/07 1:32 PM Page 15
1.Lay the wet nozzle on a flat surface with the round inlet opening facing up and the two latches close to you as shown.
2.Using both hands, position each thumb
Latches
Nozzle
Body
Removable
Insert
on the removable insert, (below the latches) and two fingers of each hand on each latch, lift and disengage the two latches from the tabs on the nozzle body.
3.Gently pull the latches toward yourself to remove the insert.
To reinstall the removable insert correctly, follow these steps:
1.Place the removable insert on a flat surface with the pins positioned upward and the latches close to you as shown. Place the rubber squeegee on the insert, with the pins fitting through the matching holes in the squeegee. (Make sure the new working edge is located farthest from you.)
2.Using both hands, lower the nozzle
body onto the insert and squeegee with the round opening of the nozzle closest to you. With fingers on the far side and thumbs holding the latches of the removable insert, flip the nozzle over so the latches are on the top and the round inlet opening is facing away from you. Make sure the squeegee stays on the insert pins.
3.Press down with each thumb below the latching tabs until you see and hear the removable insert snap into the nozzle body. Snap the latches over the locking tabs into their original position.
4.Inspect the pins of the insert to make sure they fit through the holes of the squeegee and fit into the matching slots in the nozzle body.
NOTE: If the pins are out of position, hold the nozzle assembly with both hands and gently twist in opposite directions. The insert pins should snap into proper position.
Twist | Twist |
Backward | Forward |
The wet nozzle assembly is ready for wet pickup use.
15
