Maintain the AutoPrinter
Maintain the AutoPrinter
Installing ribbons
Before installing ribbons in the printer, stop any operations.
To change ribbons in a Prism printer, refer to the PrismPlus Printer User Guide.
To change ribbons in an Everest II printer, refer to the Everest II Printer User Guide.
Cleaning method and schedule
Task | Frequency |
|
|
Cleaning the AutoPrinter | Once a week. Remove dust from the AutoPrinter and |
| surrounding work area. |
Aligning the printer | Upon installation and again if the discs are not picked |
| correctly from the printer tray. Refer to the procedures below |
| for more information. |
|
|
Aligning the printer
Everest printer
To align your Everest printer, use the following instructions.
Required tools:•T25 Torx screwdriver
•5/32” Allen wrench
1.Power on the AutoPrinter.
2.Wait for the unit to complete initialization. When initialization is complete, the active indicator light on the Everest printer illuminates.
| Note: The Everest printer takes 1 to 2 minutes to complete the initialization. | ||||
3. Prepare the unit for alignment. |
|
|
| Lift | |
|
|
| Arm | ||
a. | Manually slide the lift arm to the top of |
|
|
| |
|
|
|
| ||
| the AutoPrinter. |
|
|
|
|
b. | To place a disc in the gripper, press |
|
|
|
|
| the disc up into the gripper while |
|
|
|
|
| pressing the disc release button. |
|
|
|
|
c. | Release the disc release button. The |
|
|
|
|
|
|
|
| ||
| gripper holds the disc. |
|
|
|
|
d. | Press the printer button to open the |
|
|
|
|
| printer tray. |
|
|
|
|
|
|
| Disc Release Button | ||
|
|
|
| ||
|
| Gripper | |||
|
|
|
| ||
110656_H | 7 |
