Operate the AutoPrinter
Operate the AutoPrinter
Installing the carousel
Important: To prevent errors, the carousel should be installed before operating the software or powering on the AutoPrinter.
1.Slide the carousel into the unit so that the shaft slides in the slot opening of the bearing guide.
2.Lower the carousel with the top support bearing dropping in to the bearing guide.
3.If necessary, rotate the carousel to seat the carousel securely.
Bearing Guide | Top Support Bearing |
Shaft 
Powering on and off
Before you begin:
The carousel must be installed before you power on the system. For more information about installing the carousel, refer to Installing the carousel on page 5.
Note: The Prism printer power switch must be in the ‘on’ position. The Everest printer does not have a power switch. The Everest printer is powered on when the AutoPrinter is powered on.
The Everest printer takes 1 to 2 minutes to complete the initialization.
1.To power on the AutoPrinter, press the power switch on the rear of the AutoPrinter.
Power Switch
2.To power off the AutoPrinter, press the power switch.
110656_H | 5 |
