Rimage AutoPrinter
b. If the disc is not centered on the print | Side to Side Alignment Screws |
pad, align the printer side to side. |
|
i.Using the T25 Torx screwdriver, loosen the two side to side alignment screws.
ii.Slide the printer, not the printer tray, until the side edges of the disc and printer pad are aligned.
iii.Tighten the two side to side alignment screws.
Front to Back
Alignment Screw
c.Using either a T25 Torx driver or a 5/32” Allen wrench, turn the front to back alignment screw until the disc hangs over the edge of the print pad by 0.010” – 0.015” (0.25mm – 0.38mm).
Print Pad
5.When the printer is aligned, slide the lift arm to the top the unit.
6.Press the printer button to close the printer tray.
7.Press the disc release button to release the disc from the gripper.
Tip: Place your hand under the disc to catch it.
10 | 110656_H |
