Rimage AutoPrinter
4. Align the printer.
a.Slowly slide the lift arm down until the disc just touches the
print pad. | Printer | |
b. If the disc is not centered | Button | |
on the print pad, align the Side to Side | ||
printer side to side. | Alignment |
|
| ||
Pad
Holding Pins
Front to Back
Alignment Screw
Lift Arm
i.Using the T25 Torx screwdriver, loosen the two side to side alignment screws.
ii.Slide the printer, not the printer tray, until the side edges of the disc and printer pad are aligned.
iii.Tighten the two side to side alignment screws.
Tip: Tighten each screw in increments to prevent shifting.
c.Using either a T25 Torx driver or a 5/32” Allen wrench, turn the front to back alignment screw until there is a 1/16” (1.5mm) gap between the front edge of the disc and the raised edge of the disc retainer.
Disc 
Retainer
5.When the printer is aligned, slide the lift arm to the top of the unit.
6.Press the printer button to close the printer tray.
7.Press the disc release button to release the disc from the gripper.
Tip: Place your hand under the disc to catch it.
Side to Side
Alignment Screws
Gap
8 | 110656_H |
