TEMPERATURE CONTROLS - GENERAL
When deciding on the best position for the temperature controls, the following points should be taken into account.
•Fit the controls out of reach of children (suggested height from the floor 1.5m.)
•Avoid positions where the controllers will become hot. Do not fit them near stoves or ovens, or above radiators or heaters.
•If possible, avoid exposure to direct sunlight or positions where bright lights will make the digital display difficult to read.
•Position away from areas where the controller will be prone to splashing by cooking products such as oils and fats.
•The temperature controllers are water resistant, however they should be positioned away from areas where direct or persistent splashing could occur.
•Refer to the I.E.E electrical wiring regulations current edition for location requirements in shower and bath areas.
•The cables to the temperature controller carry only 12VDC (extra low voltage.)
•When using more than one temperature controller the signal cable should be run in parallel. That is, from controller to controller to heater, or from each controller to the heater. Do not wire the controllers in series.
The installation in every application will vary, therefore the temperature controller cable has been provided so that you may cut the length accordingly and fit the spade connectors, ensuring a good connection.
Cables are simply
15
