Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the radio.
2.Press the On / Off control to switch on your clock radio.
3.Press and release the Mode button until the FM band is selected.
2,7
4. Repeatedly press and release the Tuning Up or Down buttons to | 3 | |
tune to a station. The frequency will change in steps of 50kHz. | ||
|
If the radio is tuned to a station of sufficient signal strength with RDS information present, then the display may change to show the station name.
5. When the waveband end is reached the radio will recommence tuning from the opposite waveband end.
6. Adjust the Volume to the required setting.
44
7. To switch off your clock radio, press the On / Off control. | 6 |
|
Note:
If you find that FM reception is poor, try repositioning the wire aerial. Fully extend the wire aerial located on the rear of your clock radio. Place the wire antenna so that it is as straight as possible extending either above or below the radio. If you find that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section "Stereo / Mono setting - FM" on page 21 for further details.
17
