8.Completely undo the thumb screws from the sides of the radio and remove the mounting bracket.
9.Hold the mounting bracket against the pencil marks under the cupboard and use the pencil to mark drill centres for the fi xing screws (4).
10.Your radio is supplied with screws of two lengths. Be sure to use screws of appropriate length for the cupboard material. If those provided are not suitable for your needs, please use screws with a similar diameter and head design.
IMPORTANT: Before drilling holes and applying screws, please make sure that the screws selected are not too long. Excessively long screws may damage the interior of your cupboard.
11.Drill short pilot holes for the screws in the underside of the cupboard. (Pilot hole diameter typically 2.5mm, suggested drill depth not more than 12 - 14 mm)
12.Using the screws to fi t the mounting bracket to the cupboard taking care not to over tighten them.
13.Offer the radio to the fi xed mounting bracket and
14.Adjust the height of the radio beneath the cupboard as needed and tighten the thumb screws. Tighten by hand only.
15.Secure the mains lead and aerial as needed. The aerial has a loop formed at the free end. This can be fi xed as needed. Insert the mains plug in the nearest convenient mains socket and secure the mains lead so that it does not obstruct working in the kitchen.
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338
Mains operation
1.Position your RDK2 touch panel radio as previously described.
2.Plug the mains plug into a wall socket and switch on the wall socket.
•IMPORTANT: The mains plug is used as the means of connecting the radio to the mains supply. The mains socket used for the radio must remain accessible during normal use. In order to disconnect the radio from the mains completely, the mains plug should be removed from the mains socket outlet completely.
6
