2At the same time (within 30 seconds), press and hold the button on the receiver for over three seconds. The power-on indicator starts blinking quickly. After a brief period both LEDs should turn solid, indicating they successfully joined the network.

•The power-on indicator starts blinking fast.

•The power-on indicator will light solidly if the link is activated between both the units.

•If the power-on indicator blinks at a slower rate, the link is not successful.

Notes: If the power-on indicators of the sender and receiver blink slowly after blinking quickly for 30 seconds, it means that there is no active link between the sender and receiver. Try to connect the system as described above, using the power-on buttons on both units. For more information, please see “Troubleshooting”.

New devices must be joined to the hub device, not to other devices in the network. Therefore, when adding a new device to an existing network, you must put the device with the Green LED (the Hub) in Join mode with the device you want to add to the network.

When connecting rear and surround channels, you can see which device you are connecting to over the air by pressing the Source button. The sender’s LED will blink for a few seconds, showing the connection between the transmitter and receiver. This makes it easier to configure rears and surrounds without relying on AVR test patterns.

Listening to the systemTo listen to the system:

1Make sure that the system is powered on and that there is an active link between the sender and receiver.

2Turn down the volume level on your audio source to a minimum, then turn on and begin playing the audio source.

3Press the SOURCE button on the receiver or the NEXT SOURCE button on the remote control to select the audio source from A or B on the back of the sender.

4Adjust the volume level on your audio source or use the remote control. See the “Using your remote control” on page 26.

Note: Switch your home theater system settings from stereo to surround mode or completely turn off the stereo mode.

RF-RBKIT 23