Problem

No communication between the sender and receiver

No response when you press any button

Connecting a source device

Connecting a device

When trying to change the source on a Rocketfish unit the Power LED flashes five times.

Solution

•Make sure that the AC adapter is connected to the sender and the power cord is connected to the receiver.

•Once the power-on buttons have been held to turn on both sender and receiver and both units are in joining mode, the power-on indicators should blink quickly.

•If the power-on indicators on both units are solidly on, then a communication link has been successfully established between the units. If the power indicators on both the units are

blinking at a slower rate, press and hold the buttons on either sender or receiver for three seconds. This will put the unit into joining mode for about 30 seconds. During this time, press

the button on the other unit for three seconds, so that it will also enter joining mode. The system proceeds with the connection process between the sender and receiver. During the joining mode, the power indicators on both sender and receiver blink at a faster rate. When an active link is established between the sender and receiver, the power-on indicators on both units are solid on and do not flash.

Note: Try pressing the buttons again if the power indicators are blinking at a slower rate after blinking fast for 30 seconds.

•Try disconnecting the device from the power source to reset it.

•If your network is already full with transmitters when joining is attempted, the Source LED will blink three times and then turn off. Remove (power down) a transmitting device and try again.

•When you try to join a device to a network that has too many nodes, the device will stay in joining mode until it times out (30 second timeout). Upon timeout the unit should be on and will flash the power ring LED in a slow blink indicating it is not connected to the network.

•Your RF-RBKIT sender is in four channel lock mode. By design, these channels are not available for access by other receivers as they form the rears/surrounds of your Home Theater system. If you do wish to use them, then you should remove the four channel lock mode by moving the switch on the back of the sender to disable four channel lock mode. Both sources will then be available for all receivers.

Specifications

Sender

Audio input - stereo, speaker-level

Audio output - wireless

Power supply

Transition delay

AUX input

30 V RMS

16-bit, 48 KHz uncompressed

DC 5 V at 0.6 A

15 - 20 ms

2 V RMS (Max. input)

1 V RMS (Standard input)

RF-RBKIT 31