Back of sender

Speaker-in A

Speaker-in B

Stream A

Stream B

.

.

.

.

.

.

Up to nine receivers

Troubleshooting

Check this list for a possible solution before calling for service.

Problem

Solution

No sound

• Make sure that the AC adapter is connected to the sender and the power cord is connected to

 

the receiver.

•Make sure that all of the cables are connected correctly.

•Make sure that the receiver is not muted. (The source indicator is blinking when it is muted.)

•Make sure that the power-on indicators are lit on both the sender and receiver. If the power-on indicators are lit solidly, the communication is working correctly. If they blink at a slower rate, see the “no communication between sender and receiver” section.

•Make sure that the volume is turned up on the source device.

Sound interference

•

Move your sender and receiver slowly to find the best reception position for your system.

 

• Shorten the distance between your sender and receiver. The maximum distance is 150 ft

 

 

(45 m) (unobstructed).

 

•

Make sure that there are no obvious radio frequency interference sources near your system.

 

 

 

30