OPERATION
ADJUSTING GAIN
Do the following individually for each channel, or both equally if bridged (mono).
NOTE: Model 201S has a single gain adjustment.
To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up until distortion is audible and then turn it down a bit until the distortion is inaudible. This will be about two thirds all the way up on most source units. Next, turn the amplifier gain setting until once again distortion is audible and then back it down until the distortion is inaudible. Rockford Fosgate source units do not distort, so the volume can be used at maximum setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.
ADJUSTING CROSSOVER FREQUENCY
Placing the switch in the HP position sets the amplifier to the High Pass mode, enabling frequencies above the
Placing the switch in the AP position sets the amplifier to the All Pass mode, preventing any crossover adjustment, allowing all frequencies to pass.
Placing the switch in the LP position sets the amplifier to the Low Pass mode, enabling frequencies below the
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.
ACCESSORIES
Connecting PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
Connecting Links
Mount your Punch Amplifiers together for space reduction and a smooth look.
See our web site for other accessories to help you get the most out of your system.
www.rockfordfosgate.com
10