Rockford Fosgate FFX3 manual Muting the Amplifier, Color Options, Allen Screw

OPERATION

3.Press the Select or (right) key to enter into XOVER MODE. The screen will display "XOVER MODE" at top and "SET: ALL PASS" with flashing up and down arrows at the bottom.

4.For this example, using the (up) or (down) key, scroll through the sub-menu until "HIGH PASS" shows next to "SET:" and then press the Select key.

NOTE: If ALL PASS was set at this point and the Select key was pressed, the DSP would have gone to the title display screen and no further adjustment could be made to XOVER MODE.

5.After pressing the Select key, the display should now show "XOVER FREQ" at top and "SET: 350" with flashing up and down arrows at the bottom. 350 is the default number.

6.Press the (down) key to scroll down through the numbers until 80 shows next to "SET:". If you go too far, press the (up) key to scroll up through the numbers. Pressing and holding a key for more than one

(1) second will quickly scroll through the selection.

7.When 80 has been set, press the Select key and the DSP will return to the title screen. The amplifier crossover is now set to High Pass @ 80Hz.

Use the same procedure to set the other features of the TYPE RF amplifier to meet your application.

Save your settings

Once you have completed adjustments to the amplifier that fit your needs, save these settings to one of the GLOBAL SAVE locations.

3

4

4

NOTE: If you need help or have

specific setting procedure 5-6questions, contact Rockford Technical Support.

MUTING THE AMPLIFIER

To mute the amplifier outputs, press the (up) and (down) keys at the same time. Press the (up) and (down) keys again to un-mute. This will not change any settings in memory.

7

COLOR OPTIONS

Personalize your Type RF amplifier by
changing the top and corner plastics to	Screw
different colors. Available through our web
site or local retailer.

The corners can be changed by removing the screw at the bottom, pull the old corner up and out, install the new corner, and reinstall the screw.

The top plastic requires you to remove the cover plate from the amplifier. Do this by removing the four (4) 3/16" allen screws from each corner.

Remove the screw holding the top plastic in place, pull the old top up and out, install the new top, ensure the top fits into the notches at the back, and reinstall the screw. Reinstall the cover plate and the four (4) allen screws.

Allen

Screw

10