Roland KR7/5 Before You Start Playing, Connect the Pedal Cable, Connect the Power Cord

Before You Start Playing

Before You Start Playing

Connect the Pedal Cable

Insert the pedal cable into the Pedal connector on the rear panel of the KR-7/5.

fig.00-01

Connect the Power Cord

Insert the included power cable into the AC inlet on the bottom panel of the KR-7/5, and then plug it into an electrical outlet.

NOTE

Be sure to use the supplied power cord.

fig.00-02

Connect the Speaker Cable (KR-7)

As shown in the diagram, connect the speaker cable leading from the speaker box of the stand to the speaker connector located on the rear panel of the KR-7.

Push the speaker cable in until it clicks into position.

KR-7 Rear

Speaker connector

Clip portion

Speaker cable

NOTE

Do not place containers holding liquids (such as flower vases), insecticide, perfume, alcohol, or similar substances on top of this piano.

The speakers of this piano are mounted beneath the upper surface, and face upwards. Malfunctions or accidents may occur if liquids contact any part of the speakers.

Speakers

Setting Up the Music Stand (KR-5)

fig.00-03

(1)

(2)

(2)

1.Gently raise the music stand, then secure it in place as shown in the figure.

2.To collapse the stand, fold in the metal fittings while supporting the stand with both hands and gently fold down the stand.

NOTE

Do not apply excessive force to the music stand.

Setting Up the Music Stand (KR-7)

1.Grasping the music stand with both hands, lift it toward you until its in the upright position.

2.Use the support on the back of the music stand to keep the stand in place.

The angle of the music stand can be set to any of three

positions.

fig.mu_stand

1

2

18